Sears GR-151SPF Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Refrigeradores Sears GR-151SPF. Sears GR-151SPF User Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 0
SAFETY PRECAUTIONS
1. Check if an eiectric leakage occurs in the set.
2. When servicing current applying parts, unplug prior to
servicing.
3. In case of testing with power injecting, wear rubber
gloves to prevent electric shock.
4. If you use any appliances, check regular current, voltage
and capacity.
5. Don't touch metal products In cold freezer room with wet
hand. It may cause frostbite.
6. Prevent water flowing to electric elements in mechanical
parts.
7. When sloping the set, remove any materials on the set,
especially thin plate type(ex,: glass plates or books.).
8. When servicing evaporator part, wear cotton gloves
without fail. It is to prevent wound by sharp fin of
evaporator.
9. Leave a breakage freezing cycle to a heavy service
center. The gas in cycle inside may soil ambient air.
SERVICING PRECAUTIONS
AIR RECHARGING IN COMPRESSOR
Test the refrigeration system by connecting it electrically
before refilling operation. This is necessary to ascertain the
function of the motor-compressor and identify the defects
immediately. If the defects have been found, empty the old
system of eventual R-12 residue by breaking off the end of
the extension piece at its narrow point. (Figure 1)
Replace the filter and any damaged components. Unsolder
and pull off the piece remaining inside the service tube and
then attach an extension completely with male Hansen and
last, solder it to the same tube again. (Figure 2)
It is necessary to execute the soldering operation with
valve open so that the fumes caused by oil residue can
come out freely without blowholes between two tubes
during heating the point to be soldered.
The extension fitted with the male Hansen is connected to
the female fitting of the vacuum pump tube. (Figure 3)
Air evacuating from the system begins as soon as the
pump starts. The refrigeration system must be kept under
vacuum until the reading on the low-pressure gauge
indicates vacuum (0 absolute, -1 atm., -760 mm Hg) In any
case it is advisable to keep the pump running for about
30 minutes. (Figure 4)
POINT TO BE
BROKEN
SERVICE TUBE
EXTENSION
Figure 1
CHARGE TUBE FEMALE
EXTENSION HANSEN
POINT
Figure 2
Figure 3 Figure 4
-3-
Vista de página 0
1 2 3 4 5 6 ... 13 14

Resumo do Conteúdo

Página 1 - SERVICING PRECAUTIONS

SAFETY PRECAUTIONS1. Check if an eiectric leakage occurs in the set.2. When servicing current applying parts, unplug prior to servicing.3. In case of

Página 2

COMPRESSOR AND ANOTHER ELECTRIC COMPONENTS12

Página 4

EXPLODED VIEW14

Página 6 - DISASSEMBLY

HOME DEPOT(HDP) Electrical SpecificationITEM GR-051SF GR-131SF GR-151SFBUYER MODEL NAME GR-051SF GR-131SPF GR-151SPFRATED INPUT(W) 70±15% 70±15% 70±15

Página 7 - CIRCUIT DIAGRAM

In case that a considerable leakage occurs and to stop the vacuum pump will be necessary and add a small quantity of Freon to the system, if vacuum sh

Página 8 - TROUBLESHOOTING

AIR RECHARGING IN COMPRESSORTest the refrigeration system by connecting it electrically before refilling operation. This is necessary to ascertain the

Página 9 - NO COOLING

In case that a considerable leakage occurs and to stop the vacuum pump will be necessary and add a small quantity of Freon to the system, if vacuum sh

Página 10

SPECIFICATIONSITEMS SPECIFICATIONSDOOR TYPE 1 DOORNET CAPACITY 94 1CONDENSER TYPE WALL CONDENSER(FLUSH BACK)DEFROSTING SYSTEM MANUALTEMPERATURE CONTRO

Página 11

DISASSEMBLYA. DOOR1. Loosen 3 screws holding an upper hinge to separate the door body. (Figure 7)C. COMPRESSOR AND PTCB. THERMOSTAT1. Pull Knob Dial.2

Página 12 - EXPLODED VIEW

CIRCUIT DIAGRAMYL: YELLOW BK: BLACK BL: BLUE GN; GREENTHE PLUG TYPE ON CIRCUIT DIAGRAM IS SUBJECTTO CHANGE IN DIFFERENT LOCALITIES.J652-00041C

Página 13

TROUBLESHOOTINGОКРЕСТ effect CAUSE REMEDYGROUP PARTIALLY OR COMPLETELY OUT OF REFRIGERANT CHARGEEvaporator dose not frost even though motor-compressor

Página 14

NO COOLINGThe Compressor doesn't run.^ Check if the current flows at the contacting point of the Thermostat.Replace the Thermostat.Check the

Modelos relacionados GR-051SF

Comentários a estes Manuais

Sem comentários